Garrett Metal Detectors Sea Hunter Mark II None Uživatelský manuál stáhnout pdf (Strana 16)

4. Ensure the searchcoil connector at

the rear of the control housing is clean

and the o-ring is well lubricated; add a

little silicon grease or petroleum jelly if

necessary. Do not coat connector pins

with lubricant. Insert coil connector and

gently hand tighten. Do not over tighten.

5. Repeat Step 4 when assembling the

headphone connector at the front of the

control housing.

6. Perform a battery test by switching on

the detector, noting the number of beeps

that occur. Scan a metal object to confirm

detection. If the batteries are low or the

detector fails to operate, verify that the

battery pack and batteries are aligned

properly.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Žádné komentáře

Garrett Metal Detectors Sea Hunter Mark II None Uživatelský manuál Strana 16